On Sun, 27 Jan 2002, dreammoose wrote:
> The DOF lever is punched out of sheet steel, so I didn't see how it
> could be bent without buckling and it is quite flat. Looking closely at
> the striations on it's surface, it looks like it may be bent slightly
> just where the long curved part meets the boss the button pushes on. I'm
> not sure how to bent it to the right point, but just knowing that it
> should be touching the coupling lever is useful info. Thanks
The DOF lever should be within 1-2mm of the diaphragm coupling lever. I
pulled my mount off and scanned it as best I could on my flatbed scanner.
You can see what it should look like here:
http://olympus.dementia.org/misc/85_mount.jpg
-mark
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|
