Since the OM-10 has PLASTIC shutter curtain shafts, use with the motor
drive can cause a meltdown. Unless someone fooled with the MD switch in
the body, the 10 should not allow your motor to fire.
John
Jay Maynard wrote:
>
> On Thu, Mar 25, 1999 at 12:12:38PM -0500, John Hermanson wrote:
> > If your 10 is not working with a Winder 1 or 2 (NOT Motor Drive 1 or 2),
> > then it is most likely the MD switch in the bottom of the camera is
> > either dirty or out of adjustment. The switch does not need
> > modification to work with a winder.
>
> I've used a Motor Drive 1 on an OM-10...what doesn't work? (I didn't run it
> in sequence mode for more than a couple of frames, though.)
>
> < This message was delivered via the Olympus Mailing List >
> < For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
> < Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|