John -
Is the MD switch something I could clean adjust or does it require a
professional repair ?
Chip Kinkead
St. Louis, MO
> ----------
> From: John Hermanson[SMTP:omtech@xxxxxxxxx]
> Reply To: olympus@xxxxxxxxxxxxxxx
> Sent: Thursday, March 25, 1999 11:12 AM
> To: olympus@xxxxxxxxxxxxxxx
> Subject: Re: [OM] OM-10 Winder 1 Compatibility
>
> If your 10 is not working with a Winder 1 or 2 (NOT Motor Drive 1 or 2),
> then it is most likely the MD switch in the bottom of the camera is
> either dirty or out of adjustment. The switch does not need
> modification to work with a winder.
>
> John
>
> Kinkead, Frank W wrote:
> >
> > I have two OM-10s; one works fine with my Winder 1 and one (a newer
> OM-10
> > Quartz) does not. I recall seeing something on a FAQ about a making a
> small
> > electrical wiring modification under the baseplate of OM-10s that might
> fix
> > same. I can't recal where I saw this. Has anyone else ran across this
> > reference ? Has anybody tried to accomplish the mod ?
> >
> > Chip
> > (St. Louis, MO USA)
> >
> > < This message was delivered via the Olympus Mailing List >
> > < For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
> > < Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
>
> < This message was delivered via the Olympus Mailing List >
> < For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
> < Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
>
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|