Olympus-OM
[Top] [All Lists]

Re: [OM] Using adapted manual lenses, was: Kirk Tuck on micro 4/3

Subject: Re: [OM] Using adapted manual lenses, was: Kirk Tuck on micro 4/3
From: "C.H.Ling" <ch_photo@xxxxxxxxxxxxx>
Date: Thu, 12 Jan 2012 10:46:33 +0800
I have three plain OM-EOS adaptors and one with focus confirmation chip.
The three plain ones are exactly the same (0.02mm thinner) and the one with
confirmation chip is 0.01mm thicker so that one looks like from different
manufacturer. All adapters fit to all my 20+ OM lenses and the 5D II body.

For focusing I prefer using the EG-S screen as I prefer to focus my eye on
the object rather than on the confirmation light. At the mean time the
focusing accuracy seems not so good with the confirmation aid.

C.H.Ling

----- Original Message ----- 
From: "Chuck Norcutt" <chucknorcutt@xxxxxxxxxxxxxxxx>


> I'm talking Canon full frame, not Olympus.  My only problem has been fit
> of the mounting flange.
>
> Chuck Norcutt
>
>
> On 1/11/2012 7:09 PM, Chris Trask wrote:
>>>
>>>>
>>>>> Thanks.  Everyone I've bought previously (except the very first) even
>>>>> though from different sellers and some years apart all looked as
>> though
>>>>> they came out of the same shop.
>>>>>
>>>>
>>>>       There are at least three different manufacturers of each, it
>>>> seems,
>> and
>>>> perhaps a half dozen sellers of each of those.  I went through three
>>>> M42
>>>> adapters before I found one that fit.  When I went shopping for my
>> Minolta
>>>> MC/MD adapter I bought it from Roxsen first and I was not disappointed.
>>>> It's a bit strange as the manufacturer took out the locking mechanism
>>>> so
>> as
>>>> to get it thin enough to fit.  Instead, there's a single set screw
>>>> along
>> the
>>>> edge that tightens a brake that holds it to the lens, which is
>>>> perfectly
>>>> okay with me.
>>>>
>>>
>>
>>> Thanks again.  I'll check the Roxsens out.
>>>
>>
>>      Just one thing about using those:  When they made the adapter thin
>> enough to enable infinity focus, the aperture pin has a tendency to touch
>> the inside of the camera body and hold the aperture fully open.  For the
>> E-500, it's a matter of taking 0.015" to 0.020" off the end of the pin
>> with
>> a fine-toothed mill file.  Takes less than a minute.
>>
>> Chris

-- 
_________________________________________________________________
Options: http://lists.thomasclausen.net/mailman/listinfo/olympus
Archives: http://lists.thomasclausen.net/mailman/private/olympus/
Themed Olympus Photo Exhibition: http://www.tope.nl/

<Prev in Thread] Current Thread [Next in Thread>
Sponsored by Tako
Impressum | Datenschutz