Hi John,
I had the same problems with my ScanWit 2720s. Be sure to set the IRQ jumpers
on the SCSI card to the appropiate IRQ address. Worked fine for me, after many
tries.
Regards
Bernd
----- Original Message -----
From: "John Pendley" <jpendley@xxxxxxx>
To: <Olympus@xxxxxxxxxxxxxxx>
Sent: Thursday, August 16, 2001 8:55 PM
Subject: [OM] Help! Can't get scanner installed
> Hello everyone,
> Would somebody who know scanners please try to help me out. I've hooked up
> my Scanwit 2720S. I put in the SCSI card correctly, I think. I plugged the
> scanner to the SCSI connection, using the IN port on the scanner as
> instructed if there are no other SCSI cards, and set the number to 1. I ran
> the MiraPhoto Driver from the CD. It installed completely. I rebooted,
> attached the power cord to the scanner, and powered it up. The Status light
> blinked as it should for a few seconds and then stopped blinking. I loaded
> the slide tray with four slides and fed it into the scanner, pushed the
> Scan button and nothing happened. I have no idea what an SCSI card *is*, so
> I don't know if I have another one or not. If there is another one, the
> instructions say to attach the plug to the Out connection on the scanner
> and switch to a higher number. I did that and selected number 2. Then, I
> tried number 3. I've looked in "My Computer" and the scanner doesn't show
> up as the Smartcard reader does, for instance. I'm about ready to unhook
> everything from the computer and try reinstalling the card, but before I do
> it all over again, I thought I'd see if anyone has any idea what I'm doing
> wrong.
> Thanks,
> John
>
>
> < This message was delivered via the Olympus Mailing List >
> < For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
> < Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
>
>
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|