I turn off all Curve, USM and LCH..., I found any adjustment came out not as
expected, even cropping and curve is not precise as shown in preview. I only
use ICE, Resolution and sometimes Analog Gain for overexposed slides. For
the Color Management setting, it is always Monitor-Use factory default
monitor profile, sRGB. Sharpen and Curve is done in PS and sharpen is done
on final resized version only (for the posted samples 0.4/60 were used).
C.H.Ling
----- Original Message -----
From: "Fernando Gonzalez Gentile"
> Fortunately, I have the same flower shown in F01 ('Estrella Federal'
> <http://en.wikipedia.org/wiki/Euphorbia_pulcherrima>, but done on RVP135 -
> and lit by a T32 OTF mode. Done with OM 4, and Zuiko 21mmƒ/3,5.
>
> Shall try to follow your steps today.
> What adjustments *during* scan?
> Did you leave Curves, USM and LCH in the Tools Palette of NikonScan 4.0.2
> in Default Settings?
> What about ICE? I use a little of USM in NikonScan to counter-effect the
> softening due to ICE, around threshold 1, halo 5%, intensity 15%.
>
> Ok, I'll turn off ICE for this one ...
>
> Certainly, I see colors quite right (you are very careful on staying away
> from clipping :-) ), but lacking contrast / sharpen -> and not much, in
> fact less than what I can see when wearing my clean spectacles to correct
> my eyes for -5.
>
> :-)
>
> Fernando.
>
> ... wait a little.
>
> C.H.Ling wrote:
>> , there are a few other with RDP
>> III, check and tell me what do you think about them, the image contrast
>> is
>> very similar to what I have seen on the slides. No color adjustment after
>> scan, only minor contrast curve and slight sharpen applied.
>>
>> http://www.accura.com.hk/temp/FR/FR.htm
>>
>> C.H.Ling
>>
>
>
>
>
--
_________________________________________________________________
Options: http://lists.thomasclausen.net/mailman/listinfo/olympus
Archives: http://lists.thomasclausen.net/mailman/private/olympus/
Themed Olympus Photo Exhibition: http://www.tope.nl/
|