Re: [OM] WTB: Zuiko OM glass (21/2, 18/3.5, 90/2)

[Moose]

Chuck Norcutt wrote:
> I thought for a long time that my logo wouldn't come off either without 
> risking tearing the bag.  But I didn't want to travel 11,508 miles by car 
> with "Canyon" emblazoned in chrome across my bag. I eventually tried (and 
> succeeded) by slipping a strong, thin blade between the fabric and back of 
> the logo then held the body of the logo (with fabric) tightly in one hand 
> whilst slowly imparting a slight twist to the blade to work the push on 
> faster on the back side off the stud it was attached to.  You have to work a 
> little at a time and move the position of the blade around to pull the 
> fastener off evenly.  I have never seen the fasteners as they're still inside 
> the bag between material layers but assume they look similar to these.  
> <http://www.bakfin.com/>
>   

I did much the same thing. In my case, the posts on the back of the 
badge were pushed through a single piece of  plastic long enough to have 
two holes in the right places. They were then simply bent, with heat, I 
assume, across the cack of the piece of plastic. That backing piece is 
still in there

> If that didn't work I was prepared to take a razor blade to one or even three 
> sides of the fabric surrounding the logo, snip the studs off and then repair 
> the fabric damage with some tape.
>   

I was going to go in with a single slit from the inside to remove 
whatever was holding it on, leaving just the two small holes in the outside.

Moose
-- 
_________________________________________________________________
Options: http://lists.thomasclausen.net/mailman/listinfo/olympus
Archives: http://lists.thomasclausen.net/mailman/private/olympus/
Themed Olympus Photo Exhibition: http://www.tope.nl/