I just measured one of the said canisters against my T32 and it comes up
a bit short. I might try and cobble one together out of two of the
canisters. Is this just sort of a diffuser panel?
As to moose's post on the matter:
My diffuser isn't anywhere near that advanced! It's just one of the flat
panel sides (including a bit of curve inserted along the upper edge)
pushed into the groove. I also made a flat piece that is sorta similar
to the proper wideangle/diffuser slide-in panel. Any suggestions on a
good design?
Dan Tan
-----Original Message-----
From: olympus-owner@xxxxxxxxxx [mailto:olympus-owner@xxxxxxxxxx] On
Behalf Of Jon Mitchell
Sent: Friday, 5 March 2004 11:03 PM
To: olympus@xxxxxxxxxx
Subject: [OM] Re: How to become a flasher
I seem to remember someone on one of our London gatherings (Sam Shiell
?)
having a diffuser made from one of those opaque film cannsiters cut in
half
lengthways. The two halves (with a little chopped of the ends) fitted
nicely in front of the T32, and clipped into the grooves top and bottom
of
the front of the flash.
Neat, simple, and cheap. Easy to replace when / if lost too !
Regards,
Jon
>
> Has anyone tried to DIY themselves a diffuser for the T32? Feel like
> sharing your designs?
The olympus mailinglist olympus@xxxxxxxxxx
To unsubscribe: mailto:olympus-request@xxxxxxxxxx?subject=unsubscribe
To contact the list admins:
mailto:olympusadmins@xxxxxxxxxx?subject="Olympus List Problem"
The olympus mailinglist olympus@xxxxxxxxxx
To unsubscribe: mailto:olympus-request@xxxxxxxxxx?subject=unsubscribe
To contact the list admins: mailto:olympusadmins@xxxxxxxxxx?subject="Olympus
List Problem"
|