Moose,
No doubt you haven't seen any of my metal work :-)
However, I going after the ball peen right now d:-|
GeoW
On 1 May 2003 at 13:57, Moose wrote:
> So why not just take it off and straighten out the dents? It's just
> brass and reather easy to work. Also, what if it's not the dents, but
> something else? You might try switching base plates to be sure before
> pursuing a solution based on an assumption.
>
> Moose
>
> George Sears wrote:
>
> >Hi Zuiks,
> >Will an OM4 base plate fit and work OK on an OM2sp?
> >
> >If not, Needed, base plate for OM2sp. Mine is a bit dented and is
> >causing problems with the operation of my winder. Nuther words,
> >winder won't work on this'un but will work on the other one.
> >
> >
>
>
>
> < This message was delivered via the Olympus Mailing List >
> < For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
> < Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
>
George Sears
Savannah, GA 31406
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|