Olympus-OM
[Top] [All Lists]

Re: [OM] T32 diffuser question

Subject: Re: [OM] T32 diffuser question
From: Siddiq <iddibhai@xxxxxxx>
Date: Sat, 26 Apr 2003 23:20:56 -0700
On Sun, 27 Apr 2003 00:57:58 -0400, John A. Lind <jlind@xxxxxxxxxxxx> wrote:

The one potential flaw with ceiling bounce can be shadows on the eyes under the eyebrows. You might want to consider the Sto-Fen Omni-bounce device in small spaces such as your formal living room:
http://www.stofen.com/Info/index.htm

Haha, I ran into that shadow situation indoors and close range, but no one seemed to mind too much since diffused light was SO nice!


Problem with a T-32 is these devices work best tilted upward at 45-60 degrees. Aimed horizontally, they *will* spill light into the flash sensor. Model specifically for the T-32 is the "OM-T32." However, it works better than pure bounce by puting most of the light into bounce plus a percentage into direct illumination. I've got one that fits my Metz 40 MZ-3i which can tilt upward (about 60 degrees without tilting the sensor) and it works well with low ceilings. Works OK not tilted **if** using TTL-Auto. The work-around with the T-32 in Normal-Auto is puting a piece of opaque material in the bottom part of the Omni-Bounce that shields the sensor. I don't use mine for the Metz that much any more as both Metz units also have a secondary flash tube that will put out about 10-200f the flash power that gives a slight amount of direct while the rest can be pure bounce by tilting the head.

Looked at that as well. It would work in close indoor spaces with lots of flat reflecting walls/low ceilings really well, I think. However, I'm trying to also cover for the situation where there won't be anything to bounce off, so the Lumiquest deal looks better. Not trying to do a pro job, since I'm doing this for myself; if it comes out great, I can get a few prints made and send them to the engaged couples' family--if it all goes bad, no one's the wiser :) I'm sure there will be plenty of family capturing things thru p/s for documentation and sharing purposes :)

Thanks for all the tips and ideas, it's been wonderful!

--
/S


< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >


<Prev in Thread] Current Thread [Next in Thread>
Sponsored by Tako
Impressum | Datenschutz