I notice a lot of the film strips come back with horizontal scratch lines
(ouch), from different films and different processors, so the problem must
be with the OM-4T :-(
Fortunately, they appear to be on the non-emulsion side (e.g. they are on
the shiny side where the words such as Kodak are right side up), and the
film scanner / SW by and large do a good job of ignoring them.
I presume a good CLA will take care of it, but the CLA lords are rather
busy during the holiday season, so is there some areas I should check. I
look and clean the obvious place but don't see anything....
// richard http://www.imagecraft.com
[ For technical support, please include all previous replies in your msgs. ]
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|