I think you're right, now that I think about it. Too bad, as they could have
done it so they were interchangeable.
Tom
> Tom wrote:
> <<<Yes, but on the top, which is in the picture, the only difference is
the
> flash ready signal. What about the pins on the bottom.>>>
>
> It won't work because the pin the connector 3 is centered and on the
> connector 4 are paired equidistant from the center. Of course, you could
cut
> the pin and get manual flash control (I think...not going to try it out:).
> Think of it this way: the pin assignment is the same as on the Shoe 3 and
> Shoe 4. Since these are not interchangeable, it would fit that the TTL
Auto
> Connectors are not interchangeable.
>
> Does this make sense? Or have I misunderstood your question?
>
> --p.j.
>
>
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|