I'm thinking, would putting a spirit level ("bubble" round one) or a
couple (x and y axis lengthwise) on one of the QR plates I have (3157
bogen) be doable or not? That way I can level off the head, swap the OM on
there, and take a level picture. Or stick a lever on the head itself,
taking pains to ensure it is level in the first place?
And what about taking out the 1.13 screen and using a razor etch it off
two lines vertical, two horizontal, again to help aligning vertical/horizontal?
Comments, suggestions etc, most welcome.
/Acer V
--
The Whole Sort Of General Mish Mash http://student.ucr.edu/~siddim01
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|