Foxy,
I beg to differ with your conclusion. I have five Adaptall2 mounts.
Of these three are marked "Adaptall 2, for OLYMPUS OM,JAPAN" and two are
marked "OL, JAPAN". Much to my dismay, every one of these WILL cause
the shear problem on my OM4. The only difference in all of them as far
as the shear problem is that one of the "OL, JAPAN" marked ones has had
the screw epoxyed or something similar.
On the basis of the five that I have I cannot accept that the ones
marked "OL" are good ones.
Rand E.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Terry and Tracey wrote:
>
> Looking at my mounts, the good one has three screws placed nearly 120
> degrees apart around the mount. And a fourth screw 180 degrees from one of
> the other screws. My bad mount (bad mount, naughty mount) does not have
> these 3 screws equally spaced. The offending screw is the one near the DOF
> preview button.
>
> The good mount is OL Japan, bad mount Adaptall 2 For Olympus OM Japan.
>
> The DOF preview button is moved around along with the offending screw on the
> good mount. I had never considered this until someone posted it about the
> 300mm f2.8.
>
> Foxy
>
> -----Original Message-----
>
> >I looked to check my Tamron adaptor and it says "Japan" and "OL" on the
> back. Is
> >this the "good" mount?
> >
> >seongwan
> >
>
> < This message was delivered via the Olympus Mailing List >
> < For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
> < Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|