Your procedure seems okay.
John
Mark Dapoz wrote:
> I just finished upgrading my M.15V Control Pack 2 with NiMH batteries
> using the procedure in the FAQ (BTW, great work on the FAQ!) and I've got
> a few suggestions on the process.
>
> - when removing the single-off-sequence cover, after applying the
> solvent, use a piece of very sticky tape (eg. duct tape) to lift
> the cover off. Using tape instead of a knife blade will ensure
> the cover doesn't get damaged.
>
> - put a piece of tape on the lock slider for the fire button, it keeps
> it from falling out as you try and re-assemble the unit.
>
> - I had to use the following procedure to re-time the mode select
> switch:
> - set the switch to sequence mode.
> - loosen (do NOT remove) the three screws holding down the
> brass ring.
> - while holding down the fire button, use a pair of needle nose
> pliers to twist the centre post until the camera fires
> continuously.
> - tighten one of the screws which holds the brass ring.
> - check that single fire mode works
> - tighten the remaining two screws
> - put the spring and the big screw back on and *gently* tighten.
>
> The instructions in the FAQ state that you should turn the big screw to set
> the timing without first loosening the brass ring. I found that if I did
> that I would strip the threads in the centre nylon post (and I almost did!).
> Perhaps my control pack is different than the one used for the FAQ (control
> pack 1 vs 2 differences?). If the centre nylon post becomes stripped, then it
> will be impossible to put the spring back on and the switch will not function
> correctly. Perhaps John H can comment on what the correct procedure is.
> -mark
>
> < This message was delivered via the Olympus Mailing List >
> < For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
> < Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|