Haven't received one yet, but I'm told they are bigger than 2x2.
>
> On September 27, 2016 at 7:50 PM Bill Pearce <billcpearce@xxxxxxx> wrote:
>
> Could they be old slides from 828 film? Image area is large but mount is
> still 2x2.
>
> -----Original Message-----
> From: Chuck Norcutt
> Sent: Tuesday, September 27, 2016 5:31 PM
> To: Olympus Camera Discussion
> Subject: Re: [OM] 2x2 glass slides
>
> The "slightly larger" than 2x2 is potentially a problem depending on the
> definition of "slightly". I just measured the slide holder with my
> caliper. It only has 0.025" clearance over 2" so could be a fit problem.
> On the other hand, the entire slide holder/film gate fixture slides up
> and off its vertical support. You could then just tape a slide on the
> end of the support if necessary.
>
> Chuck Norcutt
>
> On 9/26/2016 9:57 PM, Don Holbrook wrote:
>
> > >
> > Thanks to everyone who has replied. The slides are evidently from
> > the 40s
> > or so. I haven't seen them yet. I'm told they have some sort of
> > border
> > and are slightly larger than 2x2. We'll see when I get some. I have
> > the
> > Oly slide copier, and an older Epson scanner. I may be back asking
> > more
> > questions <g>. Thanks again.
> >
> > > > >
> > > On September 26, 2016 at 7:01 PM Chuck Norcutt
> > > <chucknorcutt@xxxxxxxxxxxxxxxx> wrote:
> > >
> > > Got me... whatever is 3mm thick. B&H doesn't have images of
> > > the
> > > products that are available and whatever you get is special
> > > order.
> > >
> > > Chuck Norcutt
> > >
> > > On 9/26/2016 3:26 PM, Piers Hemy wrote:
> > >
> > > > > > >
> > > > Are we talking GePe type plastic frames with thin,
> > > > wafer thin glass? Or
> > > > a
> > > > sandwich of two 2×2 pieces of glass bound with passe
> > > > part out tape
> > > > around
> > > > the edges?
> > > >
> > > > Piers
> > > >
> > > > On 26 Sep 2016 8:04 p.m., "Ken Norton"
> > > > <ken@xxxxxxxxxxx> wrote:
> > > >
> > > > > > > > >
> > > > > > > > > > >
> > > > > > Anyhow I decided to check my Epson 700's
> > > > > > slide holder and see that it
> > > > > > *might* hold 3mm thick slides. A stack of 3
> > > > > > Kodachrome slides is
> > > > > > 3.5mm
> > > > > > thick and it *almost* fits. Removing 0.5mm
> > > > > > just might do it.
> > > > > >
> > > > > > > > > > >
> > > > > I just checked my Epson holders. I can do glass
> > > > > mounts with no problem.
> > > > >
> > > > > AG
> > > > > --
> > > > >
> > > > >
> > > > > _________________________________________________________________
> > > > > Options:
> > > > > http://lists.thomasclausen.net/mailman/listinfo/olympus
> > > > > Archives:
> > > > > http://lists.thomasclausen.net/mailman/private/olympus/
> > > > > Themed Olympus Photo Exhibition:
> > > > > http://www.tope.nl/
> > > > >
> > > > > --
> > > > >
> > > > >
> > > > > _________________________________________________________________
> > > > > Options:
> > > > > http://lists.thomasclausen.net/mailman/listinfo/olympus
> > > > > Archives:
> > > > > http://lists.thomasclausen.net/mailman/private/olympus/
> > > > > Themed Olympus Photo Exhibition:
> > > > > http://www.tope.nl/
> > > > >
> > > > > > > > >
> > > > > > >
> > > --
> > >
> > >
> > > _________________________________________________________________
> > > Options:
> > > http://lists.thomasclausen.net/mailman/listinfo/olympus
> > > Archives:
> > > http://lists.thomasclausen.net/mailman/private/olympus/
> > > Themed Olympus Photo Exhibition: http://www.tope.nl/
> > >
> > > > >
> > >
> --
>
> _________________________________________________________________
> Options: http://lists.thomasclausen.net/mailman/listinfo/olympus
> Archives: http://lists.thomasclausen.net/mailman/private/olympus/
> Themed Olympus Photo Exhibition: http://www.tope.nl/
>
--
_________________________________________________________________
Options: http://lists.thomasclausen.net/mailman/listinfo/olympus
Archives: http://lists.thomasclausen.net/mailman/private/olympus/
Themed Olympus Photo Exhibition: http://www.tope.nl/
|