Yeah, right.
On 29 July 2011 14:02, Chuck Norcutt <chucknorcutt@xxxxxxxxxxxxxxxx> wrote:
> What we saw when scanning was red light. Perhaps there is a radio
> signal as well able to pass through the tool to a density sensor or
> reflector underneath. Ever seen ground penetrating radar?
>
> Chuck Norcutt
>
>
> On 7/29/2011 2:23 AM, Andrew Fildes wrote:
> > Yes - I can accept the recreation in layers but how can the scanner 'see'
> the location pins and sockets of the adjustment wheel and the internal
> contours of the slide. We cannot be seeing the whole scanning process.
> > Andrew Fildes
> > afildes@xxxxxxxxxxxxx
> >
> >
> >
> > On 29/07/2011, at 2:10 AM, Jez Cunningham wrote:
> >
> >> Sorry, this old fart doesn't believe it...
> >>
> >> On 28 July 2011 16:06, Chuck Norcutt<chucknorcutt@xxxxxxxxxxxxxxxx>
> wrote:
> >>
> >>> Incredible. I've seen 3D printing before but never the simultaneous
> >>> creation of moving parts and in different colors. I'm amazed at 40
> >>> micron accuracy despite the scanner being hand held. And I really
> don't
> >>> understand how they were able to recreate the shafts of the adjustment
> >>> wheel without them being visible (at least to visible light).
> >
> --
> _________________________________________________________________
> Options: http://lists.thomasclausen.net/mailman/listinfo/olympus
> Archives: http://lists.thomasclausen.net/mailman/private/olympus/
> Themed Olympus Photo Exhibition: http://www.tope.nl/
>
>
--
_________________________________________________________________
Options: http://lists.thomasclausen.net/mailman/listinfo/olympus
Archives: http://lists.thomasclausen.net/mailman/private/olympus/
Themed Olympus Photo Exhibition: http://www.tope.nl/
|