Quoting "Chuck Norcutt" <chucknorcutt@xxxxxxxxxxxxxxxx>:
> Thanks, Rickard. I intended to make a similar response but it wouldn't
> have had the additional fine points of using the E-3 which I am not
> familiar with. But I can read the E-3 manual and the use of the front
> (sub) dial to set the aperture in manual mode makes no mention of
> needing to press the exposure compensation [+/-] dial at the same time.
> That makes sense to me. Perhaps you were confused?
Yes, that was a moment of confusion here :) I forgot that the E-3 have
a second dial on the front which can set the aperture directly. On
E5xx, you need to press the [+/-] button. I do not own an E-3, only
E-500 and E-520.
Regards,
Rickard Nilsson
> Chuck Norcutt
>
>
>
> Rickard Nilsson wrote:
>> Den 2009-11-02 23:46:19 skrev Brian Swale <bj@xxxxxxxxxxxxxxx>:
>>
>>> (b) Using something like the OM4 to set exposure as I already do for my
>>> manual film cameras - if I have an interesting scene where I will want
>>> to try a
>>> range of compositions (and I know that the E-3 will alter the exposure
>>> for
>>> every composition even though the illumination of the scene has not
>>> changed one iota), I will want to set one reliable combination of speed
>>> and
>>> aperture on manual and leave that constant through the set of shots.
>>
>>
>>> (d) and having stabilised exposure, I also have to simultaneously find a
>>> way
>>> to cause the camera to focus on a spot I decide upon - be it near or far
>>> -
>>> while I move the frame to get the composition I want. Easy with film -
>>> but
>>> digital ?
>>
>>
>> Chuck Norcutt described the remedy to those two points in an earlier
>> post. The trick is the following:
>>
>> * Set the camera to manual exposure and manual focus.
>>
>> * Configure the AEL/AFL setting to mode "M3". This will cause
>> the AEL/AFL button to work as a "focus-on-demand"-button. Remember
>> to activate only the middle focus point, for consisten behaviour.
>>
>> * Set the function of the thumb dial to Shutter (in Manual mode).
>>
>> * If you like, switch the FN and AEL/AFL buttons so the focus
>> function is available to you just below the thumb dial.
>>
>> With these settings, it is simple to get consistent exposure and
>> focusing:
>>
>> 1. Set ISO.
>>
>> 2. Set aperture (by pressing the +/- button and turning the
>> dial at the same time)
>>
>> 3. Point the camera towards something you like to set your
>> exposure after. You can use either spot or pattern metering.
>> Adjust the shutter time by turning the thumb dial. You can
>> directly read out the amount of over- or underexposure the
>> camera thinks you are doing, both in the viewfinder and
>> on the LCD.
>> You can configure both the direction of the thumb dial,
>> and the amount it should increase/decrease shutter time.
>> I prefer to have it to increase the shutter time a half
>> stop when I turn it right. That makes sense when shifting
>> aperture on manual Zuikos to.
>>
>> 4. Point the camera towards something you want to focus on,
>> and press the AEL/AFL (or FN) button.
>>
>> 5. Now, exposure and focus is set, you can freely compose
>> and then take the photo. The camera won't change any
>> setting when you press the shutter button.
>>
>> Since all settings will remain after the shot, you often just
>> have to change the focus for the next shot.
>>
>>
>> Regards,
>> Rickard Nilsson
>>
>>
>>
>>
> --
> _________________________________________________________________
> Options: http://lists.thomasclausen.net/mailman/listinfo/olympus
> Archives: http://lists.thomasclausen.net/mailman/private/olympus/
> Themed Olympus Photo Exhibition: http://www.tope.nl/
>
>
--
_________________________________________________________________
Options: http://lists.thomasclausen.net/mailman/listinfo/olympus
Archives: http://lists.thomasclausen.net/mailman/private/olympus/
Themed Olympus Photo Exhibition: http://www.tope.nl/
|