I finally found a website I was able to download Viewer from. I was able to
successfully install it, but when I try to update it to the most current
version I keep getting caught in a loop. The program sends me to the Oly site,
has me click on XP version, connect the camera in control mode and open the XP
driver, a couple of clicks later it has me reboot. I thought I had correctly
done this, reopened Viewer after reboot, it still says ver 1.0. So I get into
the program and click on update and start the procedure all over again. The
first time it saw my E-1, now every time after, it says it cannot see the
camera and to connect it, although it is already there. Does anyone remember,
going from ver 1.0 to I think it's 1.5 or so, having this kind of problem? Any
help or fix for it? Should I just knuckle under and pay for Studio? I want to
check or update firmware on my equipment and it was confirmed Master will not
do the E-1. TIA, Jerry
Life is not a race, it is a ride. Enjoy it!!
http://www.flickr.com/photos/proud-texan/
--
_________________________________________________________________
Options: http://lists.thomasclausen.net/mailman/listinfo/olympus
Archives: http://lists.thomasclausen.net/mailman/private/olympus/
Themed Olympus Photo Exhibition: http://www.tope.nl/
|