I have the exact same problem on my E-1 body. The rubber grip around the
red glass (plastic; presumably hiding the remote receiver) is coming loose,
but just around that red thing, so it bulks out a little bit.
Is there any clever way to fasten it, perhaps by injecting some glue (epoxy
would not be advisable in this case, so advice on adhesives is needed) with
a syringe?
J
----- Original Message -----
From: "swisspace" <swisspace@xxxxxxxxxxx>
To: <olympus@xxxxxxxxxx>
Sent: Wednesday, September 19, 2007 02:14
Subject: [OM] E1 rubber grip coming loose and 14-54 O ring
> It seems the years are starting to take its toll on my E1 and it is
> suffering from the glue not sticking around the little red plastic bit
> at the front.
>
> I remember this being discussed in the past, but can anyone recall the
> best approach to fix it, i.e remove the rubber completely and re-glue or
> use a cocktail stick and put some under where it has come loose. also
> what's the recommended adhesive - I am guessing not epoxy for this.
>
> on a side note I also noticed a small piece of rubber O ring sticking
> out of the camera end of my 14-54, I am guessing it's an easy fix - just
> undo the screws holding the chrome plate and replace the O ring it
> neatly back where it should be. Any thing I should be wary of when
> undoing the plate
>
> Iechyd da
> IanW
>
> ==============================================
> List usage info: http://www.zuikoholic.com
> List nannies: olympusadmin@xxxxxxxxxx
> ==============================================
==============================================
List usage info: http://www.zuikoholic.com
List nannies: olympusadmin@xxxxxxxxxx
==============================================
|