Surely you jest! There are 20 doors to be done. And one skill I have
never acquired is the ability to resharpen a chisel to a razor edge. My
hammer and chisel work usually beats the wood into submission rather
than cleanly cutting it. Actually, I'm not worried about the strength
of the wood holding the screw, only the difficulty of trying to drill a
new hole whose center point is sitting on the edge of the existing hole.
Chuck Norcutt
Wiliam Wagenaar wrote:
> If you are worried about the strength of the half overlapping holes and
> screws, you can also chisel out other parts of the door and place the
> hinges there. With a good chisel it would take bout 5 minutes per hinge
> to relocate it about one inch up or down. The only extyra thing you have
> to do is paint over the parts of the doors and frames that were formerly
> covered with hinges.
>
>
>
> Good luck,
>
>
>
> Wiliam
>
>
>
> ==============================================
> List usage info: http://www.zuikoholic.com
> List nannies: olympusadmin@xxxxxxxxxx
> ==============================================
>
>
>
==============================================
List usage info: http://www.zuikoholic.com
List nannies: olympusadmin@xxxxxxxxxx
==============================================
|