That parts blowup is the old version that does not show the set screw.
To separate the two halves, Unscrew the rear spanner ring. But to do
so, you'll have to loosen or remove the set screw which digs into the
threads of this ring.
___________________________________
John Hermanson
Camtech Photo Services, Inc.
21 South Lane, Huntington NY 11743
631-424-2121 | Olympus OM Service since 1977
http://www.zuiko.com | omtech1 AT verizon dot net
Mark Dapoz wrote:
> On Wed, 21 Mar 2007, Ian Manners wrote:
>
>>Hmm, now that I've gone back to check, dont undo it, it locks
>>the inside sleeves together, if you take it out, you might have
>>a problem aligning the two sleeve parts together so you can
>>get that just right turning of the inside and outside threads for
>>filters.
>>
>>Been a while since I've taken one apart to :-)
>
>
> Perhaps a parts diagram might help :-)
>
> http://olympus.dementia.org/Hardware/PDFs/T-10.pdf
>
> I seem to remember it was quite easy to take apart, just a simple rubber
> stopper was needed to twist the inner ring. Or maybe that was the T-8,
> I can't remember now.
> -mark
==============================================
List usage info: http://www.zuikoholic.com
List nannies: olympusadmin@xxxxxxxxxx
==============================================
|