Check all the tracks around the switch. If one burns through it can do this.
IIRC it's the one around the very edge of the circular section of the board.
Julian
----- Original Message -----
From: "asud journal" <asudjournal@xxxxxxxxxxxxxxxx>
To: <olympus@xxxxxxxxxx>
Sent: Monday, January 24, 2005 4:19 PM
Subject: [OM] Re: Motor drive 2 problem
>
> Yes, it could be the solution but when i retime the switch it just
> firing in single mode in all the ways.
> The sequence mode seems to have disapear. Maybe a short circuit in the
> card board?
> Loïc
> Le 24 janv. 05, à 17:00, Piers Hemy a écrit :
>
>>
>> Sounds like the rotary switch on the M15V has becone mis-adjusted.
>> Refer to
>> Scott Gomez' site that I pointed out to you previously, there are
>> pictures
>> there of what you need to do.
>>
>> --
>> Piers
>>
>> -----Original Message-----
>> From: olympus-owner@xxxxxxxxxx [mailto:olympus-owner@xxxxxxxxxx] On
>> Behalf
>> Of asud journal
>> Sent: 24 January 2005 15:32
>> To: olympus@xxxxxxxxxx
>> Subject: [OM] Motor drive 2 problem
>>
>>
>> Hello zuiks,
>> I have change the nicad batts on two m15v control packs.
>> The batts work well, but with one of the two control packs the shutter
>> fire
>> only in single mode on the two position of the dial knob.
>> The second work ok in sequence and single mode. it seems not to be a
>> problem
>> in the motor drive.
>> Maybe somebody on the the list know the problem and had already fix it?
>> Loïc
>>
>> ==============================================
>> List usage info: http://www.zuikoholic.com
>> List nannies: olympusadmin@xxxxxxxxxx
>> ==============================================
>>
>
> ==============================================
> List usage info: http://www.zuikoholic.com
> List nannies: olympusadmin@xxxxxxxxxx
> ==============================================
>
==============================================
List usage info: http://www.zuikoholic.com
List nannies: olympusadmin@xxxxxxxxxx
==============================================
|