I just used a little drop out of the hot glue gun and then worked it down to
a smooth surface.... no prolems and I switch lenses a lot on my OM-4
On Thu, 6 May 2004 16:07:50 -0700, Timpe, Jim wrote
> Good old fashioned sealing wax might fill the bill (as well as the
> hole). I've never heard this as an expressed concern with this
> particular lens though.
>
> BTW, welcome home (to the list). Judging from your intro, you'll
> fit right in. Sounds like your billfold is already several hundred lighter!
>
> >-----Original Message--
> So I'm looking for suggestions: what
> >could I use to
> >fill the screw hole on the lens that will not easily fall out,
> >will be smooth
> >and slippery enough for the little button to slide over it
> >easily, and then
> >also be readily removable (solvent?) if it becomes necessary
> >to service the
> >lens?
> >
> >
>
> The olympus mailinglist olympus@xxxxxxxxxx
> To unsubscribe: mailto:olympus-request@xxxxxxxxxx?subject=unsubscribe
>
> To contact the list admins:
> mailto:olympusadmin@xxxxxxxxxx?subject="Olympus List Problem"
--
Iowa Telecom WebMail (http://www.iowatelecom.net)
The olympus mailinglist olympus@xxxxxxxxxx
To unsubscribe: mailto:olympus-request@xxxxxxxxxx?subject=unsubscribe
To contact the list admins: mailto:olympusadmin@xxxxxxxxxx?subject="Olympus
List Problem"
|