Take bottom off, remove bracket, hack annoying part off. Cover outside of
hole with scotch tape, fill inside of hole with black epoxy, allow to dry.
Peel tape off. Rebuild.
----------------------------------------------------
John Hermanson www.zuiko.com
mail: omtech@xxxxxxxxx
Camtech, Olympus Sales & Service since 1977
21 South Lane, Huntington NY 11743-4714
631-424-2121 Turnaround 4-5 weeks
----------------------------------------------------
----- Original Message -----
From: <garyetx@xxxxxxxxxxx>
To: <olympus@xxxxxxxxxxxxxxx>
Sent: Sunday, November 16, 2003 11:33 AM
Subject: Re: [OM] Painful winder
> question: Can the thing be removed covered up somehow, or is there a
special
> technique to holding it?
>
> answer: Flat bastard (file, that is).
>
> -----Original Message-----
> From: owner-olympus@xxxxxxxxxxxxxxx
> [mailto:owner-olympus@xxxxxxxxxxxxxxx]On Behalf Of foefam@xxxxxxxxxxx
> Sent: Sunday, November 16, 2003 8:00 AM
> To: olympus@xxxxxxxxxxxxxxx
> Subject: [OM] Painful winder
>
>
> Hi,
> I had a question on my Winder 2. There's a square metal grommet sticking
> out on the side at the bottom of the grip. I assume it's an additional
> attachment for a strap or something? Anyway, the thing happens to be
> perfectly situated to cause the maximum level of pain possible in my palm,
> after 20 minutes or so of shooting.
>
>
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|