Jan,
Look at the underside of the 250 film back, where the bottom of the camera
and the motor drive would be if they were installed. On the right (take-up)
side there's a knurled knob marked 'clamp'. On the other side in
approximately the same position is a metal stop which will contact the
bottom of the camera when it's installed. If this stop is fixed in place,
the back will work only with the OM-1 and -2. If the stop is removable via
a screw, it will fit all the cameras.
Mark
----- Original Message -----
From: "Jan Sturm (GMX)" <jan.sturm@xxxxxxx>
To: <olympus@xxxxxxxxxxxxxxx>
Sent: Monday, June 02, 2003 2:14 PM
Subject: [OM] 250 Film Back 1
> Hi fellow Zuiks,
>
> I just managed to snap one of those up. The eSif mentions that a
> modification must be done for it to work properly on a 3/4 -/ Ti.
>
> Any guess what that mod might be ?
>
> bests,
> Jan
>
>
> < This message was delivered via the Olympus Mailing List >
> < For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
> < Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
>
>
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|