Well, I thought I did that. But there must be something I'm overlooking.
It's hard to believe that I can't figure this out, it's only long runs of
ribbon wire up the inside of the grip. There are no electronics at all. If
you think of anything else, I'd appreciate it. Thanks.
Bryan
----- Original Message -----
From: <clintonr@xxxxxxxxxxxxxxxx>
To: <olympus@xxxxxxxxxxxxxxx>
Sent: Tuesday, April 09, 2002 8:21 PM
Subject: Re: [OM] Modified T-45
> I suspect (if you don't have the schematic) that you can check with a
meter and
> see which pin of the TTL plug on the bracket goes to which pin going to
the T-45
> body. If it worked before you modified it, and the pins are corrected
properly,
> it should still work....
>
> Bryan Pilati wrote:
>
> > I have a T-45 that I modified because of the poor design of the base
> > attachment/contact assembly. Now I can't get it to go off under the
control
> > of the camera. The test button works fine. I'm pretty sure I have the
> > wiring correct, but can't figure out what's wrong. Any ideas, anyone
else
> > ever try to be a Olympus engineer?
> >
> > Bryan Pilati
> > OM-2N
> >
> > < This message was delivered via the Olympus Mailing List >
> > < For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
> > < Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
>
>
> < This message was delivered via the Olympus Mailing List >
> < For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
> < Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
>
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|