Thanks. Just have to get hold of a control pack and a charger then. eB*y maybe?
Henrik Dahl
As I have two MD1's and a Control Pack one and two, I can assure you the
Control Pack 2 works fine with either and early or later MD1. As a matter of
fact, It was years before I knew they were different models. Since I got the
later, small button MD1 and the Control Pack 2 at the same time, the Control
Pack 2 must have pre-dated the MD2. I'm fairly certain I would not have
purchased the MD1 had the 2 been available.
The only difference I can see is the storage place for the cap on the
Control Pack 2. If you buy a motor and Control Pack 2 at the same time, you
may already be a winner. I suspect the top plate on the 1 and 2 would be
interchagable. The charger for my Control Pack 1 works fine with the Control
Pack 2, I imagine they use the same cables.
I feel a bit like Tom with his OM2/T32 situation.
Bill Pearce
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|