One last question for any helpful XA-ers?
I'm jury-rigging the door assembly on my XA2 by putting small pieces of tape
in the channel on the inside of the door, lined up to the midline of the
viewfinder.
The location is shown in red at
http://rubicon.kataan.org/private/xa-cover.jpg
There's a channel at that point on the front where it looks like the ball
bearing rolled, and somehow it would make the door slide easier and make the
door click into place when it is fully opened.
I'd like to put the BB back the way it originally came - I like having the
door stay in place when it's open; now I'm a little worried about the door
sneaking over part of the shutter/viewfinder.
I caught the BB when it came out, but couldn't tell exactly where it came
from. Should it be in the channel on the front side, or the channel on the
back side?
Thanks,
--k
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|
