Shoe 1, 2, 3, and TTL Conn. 3 will fit OM-1, OM-2. TTL pin must be cut off
in some cases.
John Hermanson
___________________________________
http://www.zuiko.com
Camtech, Olympus Service since 1977.
21 South Lane, Huntington NY 11743-4714
Phone/fax 631-424-2121
Free Olympus Manuals: 1-800-221-3000
___________________________________
----- Original Message -----
From: "Bruce Kolber" <bkolber@xxxxxxxxxxxxxxx>
To: <olympus@xxxxxxxxxxxxxxx>
Sent: Tuesday, May 08, 2001 8:45 AM
Subject: Re: [OM] auto connector type 3
| Thanks, I have been unable to verify the thread size and direction....I
have
| a Shoe1 (fix) and an OM1 and I also have a Connector 3 but do not have an
| OM2 so I have not been able to try the Shoe 1 (fix) on an OM2 to see if
they
| are the same thread..
| Bruce Kolber
| St. Petersburg, FL 33715
| USA
| ----- Original Message -----
| From: "C.H.Ling" <chling@xxxxxxxxxxxx>
| To: <olympus@xxxxxxxxxxxxxxx>
| Sent: Tuesday, May 08, 2001 8:34 AM
| Subject: Re: [OM] auto connector type 3
|
|
| > I think the OM-1 has different screw-in direction for both hot shoe and
| TTL
| > connector (may be there was no TTL connector designed for OM-1). As
there
| is
| > no LED inside the finder, you better use a regular cord and a normal
| "remote
| > shoe" to connect your T-series flash.
| >
| > C.H.Ling
| >
| > ----- Original Message -----
| > From: "Bruce Kolber" <bkolber@xxxxxxxxxxxxxxx>
| > To: <olympus@xxxxxxxxxxxxxxx>
| > Sent: Tuesday, May 08, 2001 8:00 AM
| > Subject: [OM] auto connector type 3
| >
| >
| > Does the Auto Connector Type 3 fit an OM1 (not OM1n) if the secondary
pin
| is
| > removed?
| >
| > Bruce Kolber
| > St. Petersburg, FL 33715
| > USA
| >
| >
| >
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|