On a tablesaw use a very fine-toothed blade, such as sold for cutting
plywood. Good for cutting blocks to size. But a bandsaw with a fine toothed
blade is still better.
I'd forgotten about knife-edge jigsaw blades. Thanks.
Gary Edwards
From: kelton <kelton@xxxxxxxxxxxxxxxxxxx>
Reply-To: olympus@xxxxxxxxxxxxxxx
To: "Olympus List" <olympus@xxxxxxxxxxxxxxx>
Subject: [OM] The Kindest Cut
Date: Thu, 3 Jun 99 21:12:59 -0700
> big chunks of good quality black foam . . .
>To cut use electric turkey carving knife, bandsaw, utility knife,
tablesaw.
>All work but the some (bandsaw) make prettier work.
Thanks for the "dumpster" tip re where to find black foam; I'll check the
local computer store. The following recommendations are (obviously) for
OM gear only, making them kosher for posting: I've cut a lot of
(expensive store-bought) black foam, and have learned that it's best cut
with a smooth (knife-edge) jigsaw blade. (I suppose they make a
knife-edge bandsaw (butcher's?) blade, too, but have not tried this.) The
knife-edge jigsaw blade is a specialty blade for which you may have to
hunt around, or order online, but the results are well worth it. Dear
listreader, please remember to cut each hole a bit smaller than the O.D.
of the Zuiko or OM body it holds. (I aim for about an 1/8 inch smaller
all around, depending on size of the object). I've had real bad luck with
cutting foam on tablesaws.
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
_______________________________________________________________
Get Free Email and Do More On The Web. Visit http://www.msn.com
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|