Hi, I have a similar problem as Lee. I have a Winder 2 that only works on
the single mode; but nothing happens when switched to sequence mode. I
disassembled it and noticed one wire wasn't connected to anything. It was
orange and I couldn't see anyplace where it broke off (is it supposed to
be loose?). Two other wires were firmly attached to the switch. Any
suggestions or comments?
I also noticed that left contact where the 250 film back makes contact
was pushed all the way in and won't come back out (unlike the right one
which springs back). What could this do to the operation and how to fix
it?
Finally, if I can't figure this out, is it cost effective to have
repaired? If so, where? Or, is buying a used one more feasible?
Thanks, John
On Fri, 3 Apr 1998, R. Lee Hawkins wrote:
> Hi all:
> One of my slew of winders (a Winder 2) only seems to work in "single"
> mode, regardless of the position of the single/sequence switch.
> Otherwise, it seems to work fine. Another one seems to work fine most
> of the time, but occassionally the motor will scream along for a few
> revs before engaging and winding the film. Any ideas as to likely
> causes?
>
> Cheers,
> --Lee
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|